Push buttons

I looked near and far, but I seemed to have run out of luck with finding the push buttons. Either they were really expensive (about $20 each) or that they had run out of the lens colours that I needed. So I have decided to go for cutting the "buttons" out myself out of acrylic sheet using a laser cutter that I have access to.
As I have translucent red for the eyes, I did not need that, I just needed a translucent yellow, blue, and green. I also wanted a translucent white, which in the plastics industry they cal "Pearl" and is commonly used in shower screens. Yesterday I went to Eagle Plastics and gave a lovely gentleman my order, and today I have four sheets of acrylic of various colours 15x15 cm for only $5!

Yesterday I also went to the neighbouring store, which is a specialise electronics store called Active Electronics. They are a dealer for Altronics based in Perth. I bought 6m of rainbow 16 strand cable for $8.10 for the 6m and also ordered two "Knight Rider" LED kits to illuminate the buttons on the back of K-9's panel and also a false panel I am planning on making.This is what they say about it:

(SC May ’02) This little LED chaser kit is super easy to build and provides a bright addition to any shop display or vehicle. It features 32 bright LED’s which glow red. Built into it’s PIC micro controller are 12 patterns which can be selected at the press of a button. Speed is adjustable via an on board trimpot.

Requires 12VDC supply

Features

• 12 switch selectable light patterns • Adjustable pattern speed • Adjustable LED brightness • 2 pattern medleys